Additions:
An additional short "wiring harness" was included. At first, I didn't understand why it was included. However, I quickly learned that the new sensor points in the opposite direction and the additional harness is needed to make the wiring harness long enough to connect.
Deletions:
TBD
Diagnosis and Part Selection Advice:
How did you know this part needed replacement? Why did you choose a certain brand/part number?
Search for "abs and brake warning light" on dodgetalk.com forum pointed me to this rear wheel speed sensor.
Part Comments
What came in the box? Were additional nuts, bolts, sealant, etc. needed for the repair?
TBD
Repair / Installation tips:
Special tools needed? Have to remove other parts to reach this one? Any left-hand threads, sharp edges, messy fluids or other pitfalls to avoid?
Nothing special needed. This part is located on top of the rear differential. First remove 12mm nut (12mm deep socket) securing the brake line clamp. Next remove the 14mm stud (14mm wrench - didn't try a deep socket but will try when the new part comes in) and gently pry the part from the differential. I had to use a flat blade screw driver for some persuasion. The wiring harness should unclip by squeezing a tab on the top of the plug and gently pulling the plug loose. Reassembly is reverse of the above.
